Room Readings

When a room has a sensor connected, Sporeline keeps its readings: temperature, humidity, VPD and CO2, whichever the sensor sends. You can see them in two places: on the room’s own page, and on the page of every lot that is in it.

To connect a sensor, open Settings and go to Integrations.

On a room’s page

1. Open Locations and click the room, rack or other place.
2. Find the Room readings card.
3. Pick 24h, 7d or 30d.

You see one chart per reading, with the average, lowest and highest value over that time. Under the charts, Sporeline lists the blocks that are in the room now.

If the place has no sensor, or no readings came in during that time, the card says No environmental data for this room.

Next to a lot

1. Open the lot from Batches or Inventory.
2. Find the Room readings card, under Where the units are.

There is one set of charts for each place that holds units of the lot, the places with the most units first. Each one covers the time the lot has been in that place: from the time the lot started there or units were moved, returned or added there, to now.

The first three places load when you open the lot. Every other place shows its name and dates with a Show readings button; click it to load that place’s charts. This keeps a lot spread over many racks quick to open.

For a lot that is used up, discarded or voided, the card shows each place the lot was in, the most recently left first, each up to when its units ran out there. Where the history cannot tell, the period runs to the lot’s last entry.

Dates and chart times are on your farm’s clock: the Timezone under Settings, Configuration, Farm Profile, not the time zone of the computer you are using.

If the history on the page doesn’t go back to when the lot came in, the readings start at midnight (farm time) on the lot’s NOC date. Click Show older under History to load more.

For a lot older than 90 days, only the last 90 days are shown, from midnight farm time 90 days back counting today, and the card says last 90 days shown.

If a place had no readings in that time, the card says No sensor readings for this room in that period.

Who can see them

Anyone who can open the room or the lot can see its readings.

With an AI assistant

If you’ve connected an AI assistant to Sporeline (see Connect an AI Assistant), you can ask it about a room’s readings in plain words, like “how warm did Fruiting 1 get last week” or “what’s the CO₂ in the incubation room right now”. It uses the room_readings tool, which reads the same numbers this page charts.

Each answer covers one room and one reading: inside or outside temperature, humidity or VPD, or CO₂. The assistant gets the latest value, the average, low and high over the time you asked about, and a series of points it can describe or chart for you. Without a time, it looks at the last 7 days.

An assistant can look at up to 31 days at a time. If you ask about a longer stretch, it gets the most recent 31 days and is told the answer was cut short, so it should say so and offer to look at the earlier weeks separately. Over a long stretch the points are hourly averages, the same as the charts here, and the low and high still count every reading.

Anyone who can open the room can ask about its readings, Viewers included. The assistant only sees rooms on your farm.